cascade corporation QFM E Série Instructions De Montage page 4

I
NSTALLATION
Follow the steps shown to install the Push/Pull and Load
Push on the truck. Read all WARNINGS and CAUTIONS
carefully. If you don't understand a procedure, ask
your supervisor, or call the nearest Cascade Service
Department for assistance.
2
Turn down lower hooks
A
Open safety lockpin and turn down lower
hooks.
B
Close safety lockpin to secure hooks down.
C
Lower Push/Pull onto pallet.
A
4
Engage Attachment
A
B
C
2
B
C
A
Center truck behind
Push/Pull.
Tilt mast slightly forward
and drive forks under the
attachment.
Engage upper hooks
with carriage top bar.
1
PP0882.eps
B
C
Remove banding, attach
overhead hoist
3
Inside-to-Inside spacing
20.5–25.5 in. (52–65 cm)
PP0883.eps
A
PP0884.eps
684948-R5 EN
PP0312.eps
Adjust
Forks