Assembling The Tank Dome Telescopic Dome Shaft; Assembling The Tank Dome; Assembling The Telescopic Dome Shaft; Telescopic Dome Shaft On Which Persons May Walk - Graf PLATIN XL Notice D'installation Et D'entretien

Masquer les pouces Voir aussi pour PLATIN XL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.

Assembling the tank dome telescopic dome shaft

6.1

Assembling the tank dome

Prior assembly, the enclosed seal
is locked onto the tank neck's
profile „B". The tank dome is then
locked to the tank neck. It is
essential to make sure that the
upper seal "A" (pre-assembled) is
correctly installed.
B
A
6.2

Assembling the telescopic dome shaft

The telescopic dome shaft enables infinite adaptation of the tank to
given site surfaces with earth coverage of between 750 mm and
950 mm (Mini telescopic dome shaft) or 750 mm and 1050 mm
(Maxi telescopic dome shaft).
For assembly purposes, the enclosed profile seal (material EPDM)
is inserted into the tank dome's sealing groove and is coated
generously with soft soap (do not use mineral oil-based lubricants,
as these attack the seal). The telescope is then greased, inserted
and aligned with the surface of the site.
6.3

Telescopic dome shaft on which persons may walk

Important: To prevent loads from being transferred onto the
tank, round-grain gravel
layers around the telescope
Damage to the tank dome
during this step. The cover is then positioned and is sealed to
prevent entry by children. Tighten the threaded connection
on the cover so tightly that it cannot be opened by a child!
6.4

Telescopic dome shaft over which passenger cars may drive

If the tank is installed under areas used by passenger cars, the
collar area of the telescope
supported with concrete
layer of concrete to be installed must be at least 300 mm wide
and approx. 200 mm high all around. The permitted coverage
above the shoulder of the tank is min. 750 mm and max. 1300
mm. There are different possibilities for lengthening the tank
dome (610 mm): telescopic dome shaft with cast iron lid or
HGV loading (max. effective length 440 mm) as well as the
Adapter (max. effective length 300 mm).
Attention: Use the cast cover under all circumstances.
mail@graf.info
www.graf.info
(max. grain size 8/ 16) is filled in in
and is evenly compacted.
and telescope must be avoided
(colour anthracite) must be
(load class B25 = 250 kg/ m²). The
22 / 48
B
2
3
4
2
3
A
B
1
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

390006390007390016390017Platin

Table des Matières