Electrolux EWP 1064 TDW Notice D'utilisation page 18

18 www.electrolux.com
11.7 Cleaning the inlet hose and the valve filter
1.
1
3.
11.8 Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
Do this procedure also when you
want to do the emergency drain.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3.
Remove the water inlet hose.
4. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
2
3
2.
4.
20°
5. Put the ends of the drain and inlet
hose in a container. Let the water
flow out of the hoses.
6.
When no more water flows, install the
inlet hose and the drain hose again.
WARNING!
Make sure that the temperature is
more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
45°