Loading The Film In The Carrier - Sony UY-S77 Mode D'emploi

Loading the Film in the Carrier

Loading a sleeve film into the carrier
Loading a slide into the carrier
14
(EN)
This section explains the procedures for loading each type of film in the
carrier. For the procedures previous to loading the film, consult the
instruction manual (Software Manual) stored in the supplied CD-ROM.
Insert the film from the last frame so that the frame numbers are reversed
or the emulsion side facing you. Film is automatically fed into the carrier.
Emulsion side should
be facing you
Notes
• If the film contains a transparent portion such as an exposed area of
positive film, the film cannot be fed properly. Cut off the transparent
portion.
• The curling condition of the sleeve film and film ends may cause feeding
error. Fix the film correctly before inserting it into the carrier.
For details, see "About the conditions of film ends and remedies" on page
17(EN).
Insert the slide into the carrier with the emulsion side facing you, and push
in the carrier fully.
4 1
DX code should be located
on the bottom
Emulsion side should be facing you