Location; Tip-Over Switch - GE ACK15 Manuel D'utilisation

About the portable room heater.
Choosing a Location
I Do not use outdoors.
I To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
I Place the heater on a smooth, level floor.
I Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9 m) from the front of the heater and
keep them away from the sides and rear.
I Do not use it in areas where gasoline, paint,
flammable liquids or gases are used or stored.
I This heater draws 12.5 amps during operation.
To prevent overloading a circuit, do not plug the
heater into a circuit that already has other
appliances working.
I This heater is not intended for use in bathrooms,
laundry areas and similar indoor high humidity
locations. Never locate heater where it may fall
into bathtub or other water container.
I The heater must be operated in an enclosed area
to be most effective.
I Close all doors, windows and other outside openings
to the room.
Inlet and Outlet Vents
Take care never to place the heater where the inlet
or outlet is blocked or to place any object near the
inlet or outlet.
Always maintain 3 feet (0.9 m) minimum clearance on
all sides of the heater.

Tip-Over Switch

Take care never to knock or tip over the heater.
However, if the heater is ever accidentally knocked
or tipped over, it has a tip-over switch that will
automatically shut off the heater.
4
Always maintain 3 feet (0.9 m) minimum
clearance on all sides of the heater.
NOTE: Always use the handle when moving this heater.
If the inlet or outlet become blocked, the heater
may automatically shut off. Relocate the heater
or remove the object causing the blockage, wait
approximately 15 minutes and restart the heater.
CAUTION:
If the heater is knocked or
tipped over, use the handle to sit it upright, wait
approximately 5 minutes and it will automatically
restart in the last setting used.