Lindy 43113 Manuel Utilisateur

USB 3.0 Docking & Clone
Station for 2 SATA HDDs
User Manual
Benutzerhandbuch
Manuel Utilisateur
Manuale d'uso
LINDY No. 43113
www.lindy.com
Tested to Comply with FCC Standards
For Home and Office Use!
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - Second Edition (May 2015)
Overview
The LINDY USB 3.0 HDD Docking & Clone Station can be used as
both a dual HDD SATA docking station and a HDD cloning station.
The HDD Cloning function should be used standalone and creates a bit
by bit clone of the source HDD onto the target HDD.
Features
• Connects 2 SATA HDD/SSDs to a computer using a single connector
• Accepts 1.8/2.5/3.5" HDD/SSDs with 22 pin SATA combo interface.
For Micro SATA please use LINDY adapter No. 33502.
• Computer connection via USB 3.0
• SATA 3.0Gbps standard
• USB 3.0 SuperSpeed Interface up to 5Gbps, Plug and Play
• Compatible with Windows XP/Vista/7/8, Mac OS 10.8 and above,
Linux 2.6.31 or above (drivers included, native support)
Package Contents
1x SATA Docking & Cloning Station
1x Power Supply 100-240VAC / 12V DC 3A
1x Power Cord
1x USB 3.0 cable
1x This Manual
English
Deutsch
Français
Italiano
English Installation and Use
• Connect the power supply
• If you want to clone HDDs, do not connect the Docking Station to
your computer
• For normal docking station operation connect the Docking Station to
your computer via USB 3.0 cable
• Insert the HDDs to the docking station and press the power switch
ON
• Wait until the drivers are loaded by the operating system – you
English
should then see the drives in the file manager program
• HDDs may need to be partitioned / formatted using your operating
system disk management utility before you can access them.
• Before unplugging HDDs make sure data transfer processes are
completed and that the activity light is not lit.
Using the CLONE function
• Install the source and target HDDs into the appropriately labelled bay
A (Source) and B (Target)
• The target HDD must be of equal or larger capacity than the source
HDD
• Make sure target HDD is empty and not partitioned
• Press the power switch ON. The LED "R/W" will light up green.
English
• Press the CLONE button three times consecutively until 25% LED
starts to flash. Percent status changes as clone progresses. All 4
LEDs light up green once the clone process has ended. Do not
switch OFF or unplug the HDDs during the cloning process!
English
English