4. If necessary, connect the audio jack
.
➋
Installing the Mount
Installing the Handlebar Base
The device includes parts for two
handlebar installation solutions.
Installing the U-bolt and Handlebar
Base
1. Place the U-bolt
handlebar
, and thread the ends
➋
through the handlebar base
➌
2. Tighten the nuts to secure the base.
NOTE: The recommended torque is 50
lbf-in (5.7 Nm). Do not exceed torque of
80 lbf-in (9.0 Nm).
around the
➊
.
➌
➊
➋
Installing the Handlebar Base to
the Clutch-Clamp or Brake-Clamp
Brackets
1. Remove the two factory bolts on your
clutch-clamp or brake-clamp bracket
.
➊
➋
NOTE: Both 1/4 in. standard and M6
bolts are included. Match the size of
the factory bolts on your clutch-
clamp or brake-clamp bracket.
2. Thread the new bolts
handlebar base
clutch-clamp or brake-clamp bracket.
3. Tighten the bolts to secure the base.
➊
➌
➍
through the
➋
, spacers
, and
➌
➍
3