SCS Sentinel DAAF-1Y-CE Manuel D'installation Et D'utilisation page 20

5.1 At the place where you are going to install
5.2 Remove the mounting bracket from your unit
5.3 Place the bracket so that the two longest
5.4 Remove the bracket.
5.5 Using a 3/16 - inch (5mm) drill bit, drills two
5.6 Using the two screws and plastic wall plugs
5.7 Line up the slot of the bracket and the
5.8 The steps to open the battery cover and to
(1) To power smoke detector requires a battery.
(2) Match terminals on the end(s) of the battery
(3) When terminals are properly matched, push
DAAF 1Y PS-NOTICE_0314.indd 20
the detector, draw a horizontal line six inches
long.
by rotating it counterclockwise.
hole slots are aligned on the line. In each
of keyhole slots, draw a mark to locate a
mounting plug and screw.
holes at the marks and insert plastic wall
plugs. Put the detector away from getting
plaster dust on it when you drill holes for
mounting.
(all supplied), attach the bracket to the wall.
detector. Push the detector onto the
mounting bracket and turn it clockwise to
fix it into place. Pull outward on the detector
to make sure it is securely attached to the
mounting bracket.
install the battery are listed as follows:
with opposite terminal connections on the
detector.
battery firmly in until it snaps and cannot be
shaken loose.
- 20 -
ENGLISH
03/04/2014 18:16:27