KRESS 1-2-FIX Mode D'emploi page 13

Safety rules
Tools not in use must be locked away
safely in a dry place out of the reach
of children.
Switch the power tool off immediately
if the tool insert gets jammed. Be pre-
pared for high torque levels if the tool
kicks back.
The tool insert jams if:
the power tool becomes overloaded or
the tool tilts in the workpiece
Residual risk. Although this information sheet
and the operating manuals for our electrical tools
contain extensive instructions on safe working
with electrical tools, every electrical tool involves
certain residual risks that cannot be completely
prevented through safety mechanisms. Therefore,
electrical tools must always be operated with the
necessary caution.
Battery safety instructions
Do not use faulty or deformed batteries.
There is a risk of explosion.
Do not open the battery.
Danger of shortcircuiting.
Never short-circuit the battery.
There is a risk of explosion.
Protect the battery against heat or
temperatures over 50°C , e. g., also
against continuous sun irradiation
and fire.
There is a risk of explosion.
In case of damage and improper use of the bat-
tery, vapours may be emitted. Provide for fresh air
and seek medical help in case of complaints.
The vapours can irritate the respiratory system.
When the battery is defective, liquid can escape
and come into contact with adjacent components.
Check any parts concerned.
Clean such parts or replace them, if required.
Cover the battery terminals when storing outside
the charger.
There is danger of fire and explosion through short
circuits caused by metal objects.
Charger safety instructions
Never use the electric device with a
damaged cable. Do not touch the
damaged cable and pull the mains
plug when the cable gets damaged
during operation.
Damaged cables increase the risk of
electric shock.
Do not operate the unit on easily inflammable sur-
faces (e. g. paper, textiles, etc.) or in inflammable
environments.
Fire hazard due to occurring heat build-up.
Protect the electrical device from rain
and moisture.
The penetration of water in a battery
charger increases the risk of electric
shock.
Do not cover the ventilation slots during the charg-
ing process.
They preserve the battery and the battery charger
from overheating.
Do not charge the batteries of other manufactur-
ers.
The device is only suitable for the charging of
KRESS batteries. There is otherwise a risk of fire
and explosion.
Keep the battery charger clean.
Contamination may result in danger of electric
shock.
Check the electrical device, cable and plug each
time before using. Do not use the electrical device
when defects are detected. Do not open the elec-
trical device yourself and have it repaired only by
qualified personnel using original spare parts.
Damaged electrical devices, cables and plugs in-
crease the risk of electric shock.
-WARNING-
Do not open the charger! Caution high voltage!
There is a risk of electric shock.
Ensure that the connection between the charger
and the battery is correctly positioned and is not
impeded by foreign bodies.
There is a risk of fire and explosion through short
circuits caused by metal objects.
Ensure that the battery charging compartment
does not have any foreign objects and protect
English 13
EN
1-2-Fix-EN / 0905