Witter SA14A Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar with European facing to 94/20/EC A50-
D 4 M12 x 35 x 1.75 Bolts, Lock Washers and Flat Washers (25mm O.D).
E 1 ZEP35 Electrical plate (not shown)
CB 2 M16 x 50mm Coupling Bolts, Nuts, Lock Washers
FITTING
1. Remove Bumper.
ALTEA: (5 tip screws in each wheel arch, top tip screw is hidden below trim, 8 tip screws along bottom edge of bumper, 2 tip
screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on back
of light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps,
reversing light and reversing sensors (if present) and slide bumper rearward.
TOLEDO: (5 tip screws in each wheel arch, top tip screw is hidden below trim, 7 tip screws along bottom edge of bumper, 2
tip screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on
back of light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps,
reversing light and reversing sensors (if present) and slide bumper rearward.
LEON: (4 tip screws in each wheel arch, top tip screw is hidden below trim, 7 tip screws along bottom edge of bumper, 3 tip
screws under each light cluster. (To remove light cluster, remove small panel on inner trim and undo large plastic nut on back
of light, remove 2 tip screws through plastic trim to inner side and slide light cluster rearward). Disconnect fog lamps,
reversing light and reversing sensors (if present) and pull bumper edges outward.
2. Remove crash beam and refit bolts into back panel to prevent ingress of water. Hand crash beam to final user for refit
when bar is removed.
3. Insert towbar (A) into chassis rails and attach using bolts (D) in position shown. Note holes in chassis side may be hidden
under tape.
4. Cut bumper as shown and refit, it is advisable to protect bumper around neck area whilst refitting.
Note: This towbar must be used with either a Witter Towball (part number Z11) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200 Nm
WITTER TOWBARS Deeside Ind. Park, Deeside, CH5 2NY www.witter-towbars.co.uk
W0001SA14A-FIT$011103150000LÄ
W0001SA14A-FIT$011103150000
TOWBAR
SA14A
For
Seat Altea 2004 –
Seat Toledo 2004 –
Seat Leon 2005 –
Issue 1