Wagan Tech IONBoost V10 Guide D'utilisation page 9

Brief Recap of Sequences for Connection and Disconnection
Read the remainder of the instructions before using the iOnBoost!
ORDER OF CONNECTION
1. Connect positive (red)
clamp to positive battery
terminal.
ORDER OF DISCONNECTION
1
1. Turn off power
Jumpstart Procedure
1. Make sure iOnBoost is fully charged.
2. Turn off the vehicle ignition and all accessories (radios, lights, air conditioners), and
disconnect electronic devices.
3. Set the emergency brake and put vehicles with automatic transmission in park position.
4. Determine the polarity of the vehicle's battery terminals. The positive (POS, P, +) battery
terminal usually is red and larger in diameter than the negative (NEG, N, −) terminal. If you
are unsure, first refer to the vehicle owner's manual. Make sure the negative battery terminal
is also connected to the vehicle frame.
5. If engine was recently cranked, use a non-conductive material (cardboard or a folded
newspaper) to wave away (dispel) explosive gases. Do this for a few minutes before any
vehicle connections.
6. Remove the jumpstarter clamps from the storage posts.
 Never allow clamps (positive & negative terminals) to touch together or contact the same
piece of metal to prevent short-circuits and arcing�
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
2
1
2. Connect negative (black)
clamp to solid metal ground
on engine or frame, away
from battery).
2
Disconnect negative
2.
(black) clamp
from frame.
©2015 Wagan Corporation. All Rights Reserved.
3
3. Turn on power
3
Disconnect positive
3.
(red) clamp from positive
battery terminal.
9