JUMO variTRON 500 Notice De Montage page 57

Note: The cover does not need to be removed from the DIN rail if there is sufficient space to the side
to move it at least 10 mm to the right.
5. Move the modules (B) on the right next to the central processing unit (A) to the right (B4) until the
side contacts of the central processing unit are exposed.
These modules are now isolated from the voltage supply and the system bus.
6. Insert a suitable screwdriver (F) into the unlocking slot of the central processing unit (A5) and press
upward (F6).
7. Pivot the central processing unit (A) upward off the DIN rail (A7) and remove it.
2 Mounting
19