Lenovo RP300 Série Mode D'emploi page 8

1. LCD screen
2. MODE button: Selects the setting mode.
3. PROJECT button: Projects the time onto the ceiling.
4. ADJUST button: Changes the number and activates the snooze function.
5. SET button: Selects a setting.
6. RADIO OFF / ON / VOLUME knob: Roll the knob to turn the radio on or off and
increase or decrease the volume.
7. Battery compartment (at the bottom of the unit)
8. Radio antenna
9. Projector
10. SCAN button: Search the radio frequency to find radio channels.
11. RESET button: Resets the radio frequency so you can start scanning for
channels from the beginning.
Your Radio Alarm Clock Projector works with 4 x 1.5V
(not included).
When you use the RP300 for the first time:
1. Using a screwdriver, open the battery
compartment cover located at the bottom of the unit.
2. Install the 4 x AA 1.5V
observing the polarity markings inside the battery
compartment.
3. Close the battery compartment and tighten the screw.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to be
inserted with the correct polarity. Exhausted batteries are to be removed from
the product. The supply terminals are not to be short circuited. Do not throw
batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur, reset
the unit or remove the batteries and insert them again.
Battery information
batteries (not included)
8
AA / LR6 type batteries
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6
1.5V AA OR LR6