Publicité
Les langues disponibles
Les langues disponibles
2. Remove the protective strip and apply the Velcro.
3. Take the ear speaker [b] and attach it to the Velcro.
4. Adjust the microphone arm [b] along down to where your mouth will be.
6.4 Connecting the ear speaker and microphone to the main body
Carefully connect the USB cable to the USB port [4] of the main body.
Now the INTERCOMBT is installed successfully.
7. Charging
•
Before first time use, please charge the INTERCOMBT battery fully. This
usually takes about 2 hours.
•
Afterwards, each charge cycle may take up to 2 hours.
•
The indicator LED lights red when charging and is off when charging is
complete.
•
If you have not used the item for a few months, the LED may not light
red immediately when charging. It can take 15-35 minutes before the
LED turns red.
•
We suggest fully charging the INTERCOMBT at least every two months.
Note: When the battery becomes low, the LED flashes red and the
INTERCOMBT emits 3 tones every 30 seconds. Please recharge the battery
fully as described above.
If you cannot turn on the Bluetooth interphone, start charging it; then you
can turn it on.
V. 01 – 29/06/2012
INTERCOMBT
5
©Velleman nv
Publicité
