Velleman INTERCOMBT Mode D'emploi page 4

6. Installation
Caution: Test if the INTERCOMBT works correctly before you fix it in its
final position.
6.1 Attaching the intercom Velcro to the helmet
Caution: Check the position of the Velcro carefully. Once fixed, it will not be
possible to move it without damaging the Velcro.
1. Find the best location for the headset on the helmet, and make sure it is
clean and dry.
2. Attach the shaping mat [c] to the location.
3. Remove the protective strip from the double-sided adhesive and
carefully fix the Velcro [d] to the surface of the plastic pad [c].
6.2 Installing the main body
1. Take the main body [a] and remove the protective strip.
2. Make sure that the USB port [4] points down and attach the main body
to the Velcro.
6.3 Installing the ear speaker and microphone
1. Take the speaker Velcro [e] and test for the best position to fix it. The
Velcro should be fixed inside the helmet, as close as possible to the ear.
Caution: along to find the optimal position. Once fixed, the equipment
will not be easy to move.
V. 01 – 29/06/2012
INTERCOMBT
4 ©Velleman nv