Renkforce BT-RSD1802K Notice D'emploi page 64

Operation
RETUNE L / S
RETUNE L: When the radio does not receive traffic announcements any more, the auto-scan starts
90 seconds later.
RETUNE S: When the radio does not receive traffic announcements any more, the auto-scan starts
30 seconds later.
MASK DPI / ALL
Device reaction during channel search:
MASK DPI: Alternative frequencies with different programme information (PI) are not considered.
MASK ALL: Alternative frequencies with different programme information (PI) and alternative frequencies with a
high signal strength but without RDS information are not considered.
EON TA LO / DX
Device reaction when switching to EON traffic announcements:
EON TA LO: The device only switches to EON traffic announcements when the EON transmitter signal strength is
good and no interferences are to be expected.
EON TA DX: The device always switches to EON traffic announcements; signal strength is not considered.
TA VOL
In case of traffic reports and activated TA function, the pre-set volume is selected where the volume set is lower.
Set the desired volume by turning the VOLUME rotary control (9).
REG ON / OFF
REG ON: The device only switches to a different frequency with exactly the same program if the reception grows
weaker.
REG OFF: When the reception grows weaker, the device switches to another transmitter with the same regional
identification.
64

Operating Instructions
English