Maintenance; Installation; Mounting/Removal - Westermo TD-29 AC Manuel D'installation

5. Maintenance

No maintenance is required, as long as the unit is used as
intended within the specified conditions.

6. Installation

6.1 Mounting / Removal
Before mounting or removing the unit:
Prevent damage to internal electronics from electrostatic
discharges (ESD) by discharging your body to a grounding
point (e.g. use of wrist strap).
Prevent access to hazardous voltages by disconnecting the unit
from AC/DC power supply and all other electrical connections.
Mounting
This unit should be mounted on 35 mm DIN-rail which is horizontally mounted on a wall
or cabinet backplate.
This unit uses convection cooling.To avoid obstructions to the airflow around the unit,
use the following spacing rules. Recommended spacing 25 mm (1.0 inch) above/below
and 10 mm (0.4 inches) left/right the unit.
Snap on mounting, see figure
Min
10 mm
(0.4 inches)
Removal
Press down the black support at the back of the unit
using a screwdriver, see figure.
GB.22 6611-2001