Alecto COA26 Mode D'emploi page 36

• This CO detector only sounds the alarm when carbon monoxide is present at its sensor.
Therefore, it's possible for carbon monoxide to be present elsewhere and the alarm doesn't
sound.
• When the alarm sounds, possible harmful carbon monoxide levels are present!
Carbon monoxide can be deadly!
CO
concentration
50PPM
The maximum concentration a healthy adult can withstand in 8 hours.
200PPM
After 2-3 hours, mild headache, sensations of weakness, dizziness, nausea.
400PPM
Within 1-2 hours, ache in forehead; after 3 hours, life-threatening.
800PPM
Within 45 mins, dizziness, nausea, convulsions; Loss of consciousness within 2 hours;
Fatal within 2-3 hours.
1600PPM
Within 20 mins, headache, dizziness, nausea; Fatal within 1 hour.
3200PPM
Within 5-10 mins, headache, dizziness, nausea; Fatal within 25-30 mins.
6400PPM
Within 1-2 min, headache, dizziness, nausea; Fatal within 10-15 mins.
12800PPM
Fatal within 1-3 min.
Alarm
When the CO detector sounds the alarm, carbon monoxide (CO) might be present
which can be fatal. Therefore, never ignore this alarm.
On alarm, the red ALARM LED will flash rapidly 8 times and emit 8 short audible beeps. When the carbon
monoxide concentration drops below 40PPM, the alarm will stop.
What to do when the alarm sounds:
1. Open doors and windows and immediately do outside into the fresh air. Check whether
everybody has left the building.
2. Call an official installer to inspect the correct functioning and state of maintenance of the
combustion source (gas or oil powered equipment) that could be the cause for the CO
alarm.
3. Only enter the building again after the cause has been resolved and the building has been
well ventilated.
The alarm sound can be turned off for 10 minutes by pressing the TEST button (<150PPM).
If the CO concentration drops, the alarm will eventually stop automatically.
Period of inhaling and symptoms
36