Description Of The Appliance; Reversing The Door - LIMIT LIKO102 Mode D'emploi

Description of the appliance

View of the appliance
1. Removable Shelves
2. Crisper Cover
3. Crisper
4. Adjustable feet
5. Recessed Handle
6.Light
7.Light Switch
8.Bottle Racks

Reversing the door

The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it's
back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the
cooling pipes at the rear of the refrigerator.
1
2
3
4
1.Remove the upper hinge cap (7).
2.Remove the two
connect the upper hinge (5) on the right side
of the cabinet top.
3.Carefully lift the door and place it on a
padded surface to prevent scratching.
4.Remove the plug (9) and transfer it to the
uncovered hole on the right side of the unit.
Be sure to press the button firmly into the
hole.
5.Remove the two screws(7) that hold the
lower hinge (2) on the right side of the unit.
6.Remove the screw-type leveling front leg
(4) and transfer it to the right side as shown
in the adjacent figure.
7.Set the door into it's new place making
sure the pin enters the bushing at the lower
frame section (hole).
8.Secure the upper hinge (5) previously
removed in step 3 on the left side of the
unit.Make sure the pin enters the bushing on
the upper frame section (hole).
9.Loosely secure the lower left hinge (2) and
do not tighten the bolts until the door is in
the closed position and leveled.
10.Insert the plug
holes (right side).
11.Replace the upper hinge cap (7).
5
6
7
8
screws blot (6) that
(9) on the uncovered
9