Installation - Belkin F5U217ea Manuel D'utilisateur

P74081ea-B_F5U217_man.qxd 23-06-2003 14:36 Page 4

INSTALLATION

1. Plug the AC adapter into a wall outlet or surge suppressor.
Plug the DC connector into the DC power jack found on
the side of the Hub.
Note: The Hub may be used without the power supply when
connecting low-power devices such as keyboards and mice.
Remove the USB A cable connector from its built-in storage
bay, then plug it into the downstream port of your computer,
or downstream port of another hub (see Fig. 1).
Upstream Port
Figure 1
Important Note: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed mode
(480Mbps data rate). If the Hub is connected to a USB
1.1-compliant host, it will operate only in low-speed
or full-speed mode (1.5Mbps/12Mbps).
2. Your Windows operating system will now detect your
Hub and install the required driver support. (The Windows
Port 1 Port 2
Port 3
Port 4
4
INSTALLATION
(CONTINUED)
"Install New Hardware Wizard" may prompt you to
provide your Windows Installation CD to complete the
driver installation process).
Important Note: Hi-Speed USB 2.0 hub drivers are
included with most USB 2.0 PCI upgrade cards, and
are pre-installed along with the PCI card drivers.
If you purchased an upgrade card prior to the release
of Hi-Speed USB 2.0 hub support, please check with your
PCI card vendor for an updated USB 2.0 driver.
The Belkin Hi-Speed USB 2.0 driver supports all
competitive cards based on the NEC host controller
with the exception of Adaptec. The most recent Belkin
driver is available at www.belkin.com.
3. Plug the USB A connector of the USB device, or an
additional hub, into any of the downstream ports of
the Hub (see Fig. 2).
USB-A Connector
Figure 2
Important Note: When plugging a USB device into
the Hub for the first time, it may be necessary to reinstall
the USB drivers for that device. Likewise, if you move the
device to another port on the Hub, it may be necessary
to reinstall the drivers.
5
En