Operation - Audiovox FTS 100 Mode D'emploi

INITIAL OPERATION
ON/OFF
Connect the separate mains adapter to the rear of the FTS 100. Connect the audio
sources to the desired AUX inputs (RCA) on the rear of the device, as well as the
subwoofer if available. Insert the mains adapter into an electric socket and switch on
the FTS 100 using the power switch on the rear. Now press the STANDBY button on
the front of the device or on the remote control. The device is now in the STANDBY
mode.
INPUT MODE
Press the INPUT button on the front of the device and choose between AUX1, AUX2
and AUX3. You can select these inputs directly by using the AUX buttons (1, 2, 3) on
the remote control.
VOLUME CONTROL
You can use the MASTER VOLUME controller on the front of the FTS 100 or the VOL
(+/-) buttons on the remote control.
The volume of the subwoofer can be adjusted by using the SUB VOLUME (+/-)
buttons on the remote control.
MUTE
If you press the MUTE button on the front or on the remote control, the sound of the
FTS 100 will be muted. Pressing one of these buttons again will deactivate the mute
function.
SETTING THE TIME
If you press the SET button on the remote control, the hours will start to flash. You can
now set the correct time by using the "5 " "6 " buttons. Pressing the SET button again
will make the minutes start to flash; use the same method to set the minutes. Confirm
the correct time by pressing the SET button once again.
PLEASE NOTE
Please also observe the instruction manuals for the other connected devices.
Some DVD players deliver a very high output level. If distortions occur at high
volumes, decrease the volume on the device by using the MASTER VOLUME
controller; doing this will prevent causing damage to the amplifier or the speakers.
16