Description Of The Remote Control - Audiovox FTS 100 Mode D'emploi

DESCRIPTION OF THE REMOTE CONTROL

1. Standby/Power
Switches the device on/off.
2.Input
AUX1: Press this button to activate the AUX1
input.
AUX2: Press this button to activate the AUX2
input.
AUX3: Press this button to activate the AUX3
input.
3.Effect
Pressing this button will activate the 3D
sound effect. Pressing the button again will
deactivate the 3D sound effect.
4.Set
Button for setting the time.
5.Subwoofer Volume +/-
Increases/decreases the volume of the
subwoofer.
6.Mute
Switches the sound on/off.
7.
Press these buttons to set the desired time.
8.Master Volume +/-
Increases/decreases the overall volume
Inserting/replacing the battery
The remote control is powered by a pre-installed lithium
battery. An isolating strip has been inserted to prevent the
battery from running out before the device is used. Please
remove this before the first use.
If the remote control doesn't work flawlessly, the battery must
be replaced with a new battery of the same type.
Open the battery compartment. Remove the battery from the
compartment in the direction of the arrow. Before removing
the empty battery please observe its exact position. The "+"
symbol must face upwards otherwise the remote control will
not work and it could become damaged. Exchange the
battery and slide the compartment closed again.
Battery disposal
Old batteries are hazardous waste and must be
disposed of in accordance with current regulations.
1
2
3
EFFECT SET
4
5
15
AUX1 AUX2 AUX3
SUB VOL
SUB
VOL
6
7
8