Troubleshooting; Technical Data - DS Produkte 03775 Mode D'emploi

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
No heat is produced.
The device gets too
warm.
The device makes
noises.
Smoke emerges from
the device.

Technical Data

Model number:
Article number:
Timer:
Voltage supply:
Power:
Protection class:
Mains adapter
Model number:
Input:
Output:
Protection class:
17
Possible cause / solution
• Has the ON/OFF button (1) been pressed properly?
• Is the mains adapter inserted in the plug socket?
• Is the plug socket defective? Try another one.
• Check the fuse of the mains connection.
• Is the connecting cable connected correctly to the mains
cable of the mains adapter?
• The device has switched off automatically after operating
for 15 minutes. Press the ON / OFF button (1) again.
• There is too much weight on the device.
• Is the red light and heat switched on?
• Was it in operation several times in succession for 15 min-
utes / too long in each case? Pull the mains adapter out of
the plug socket and allow the device to cool down. Always
disconnect the device from the mains when it is not in use.
• Operating noises are a normal consequence of the me-
chanics and not a defect.
• Pull the mains adapter out of the plug socket immediately
and contact the customer service department.
WDL-6033
03775
15 minutes
12 V DC
max. 25 W
III
KYL-01202000O
100 – 240 V ~ 50 / 60 Hz, 0,2 A
12 V DC, 2 A, 24 W (max.)
II
EN