Hive View Guide D'utilisation page 5

Attach
base plate
to wall
When mounting the camera:
• Take the base plate from the box and
use it to mark out where the screws will
need to go on the surface where you are
mounting it.
• Drill holes where you have marked and
insert the wall plugs (anchors) from the
box into the holes.
• Take the screws from the box and screw
in the base plate, taking note of which way
the recess for the power cable is facing.
• Attach the camera to the base plate.
The magnet in the bottom of the base
will secure it in place.
Information
• Your camera can be used on battery power
temporarily. For it to work correctly it must be kept
plugged in or have its battery charged, and it must
be switched on.
• Your camera uses a non-removable, rechargeable
lithium-ion battery which will charge when the
camera is connected to mains power.
• Your camera can also be detached from the arm.
• The rechargeable battery is intended for occasional
use and should not be used as the primary method
of powering the camera.
• Your camera, its power supply and its power cable
should be kept out of reach of children.
• For indoor use only.
• Keep away from heat sources such as direct
sunlight or radiators to avoid overheating or
damaging the camera.
• Place in an open area which allows for ventilation.
• 0-35°C operating temperature.
• Not intended for use as a security system, for
medical monitoring, or to replace personal
supervision of children.
• May not work as expected in certain circumstances.
• Must only be used with the power supply and
cable provided.