for_q Q-ARM 4038 BASIC Mode D'emploi page 68

c) Always be sure of your footing on
slopes.
d) Walk, never run.
e) Mow across the face of slopes,
never up and down.
f) Exercise extreme caution when
changing direction on slopes.
g) Do not mow excessively steep
slopes.
h) Use extreme caution when re-
versing or pulling the machine to-
wards you.
i) Stop the blade(s) if the machine
has to be tilted for transporta-
tion when crossing surfaces other
than grass, and when transport-
ing the machine to and from the
area to be used.
j) Never operate the machine with
defective guards or shields, or
without safety devices, for exam-
ple deflectors and/or grass collec-
tor, in place.
k) Switch on the motor carefully ac-
cording to instructions and with
feet well away from the blade(s).
l) Do not tilt the machine when
switching on the motor, except if
the machine has to be tilted for
starting. In this case, do not tilt it
more than absolutely necessary
and lift only the part, which is
away from the operator.
m) Do not start the machine when
standing in front of the discharge
opening.
n) Do not put hands or feet near or
under rotating parts. Keep clear of
the discharge opening at all times.
o) Do not transport the machine
while the power source is running.
p) Stop the machine, and remove
plug from the socket. Make sure
that all moving parts have come
to a complete stop.
- whenever you leave the ma-
chine,
- before clearing blockages or un-
clogging chute,
134 EN
- before checking, cleaning or
working on the machine,
- after striking a foreign object,
inspect the machine for damage
and make repairs before restart-
ing and operating the machine,
- if the machine starts to vibrate
abnormally (check immediately)
and inspect for damage,
- replace or repair any damaged
parts,
- check for and tighten any loose
parts.
q) Keep the supply flexible cord away
from hazardous moving parts to
avoid damage and risk of electric
shock.
r) Avoid using the machine in bad
weather conditions especially
when there is a risk of lightning.
MAINTENANCE AND STORAGE
a) Keep all nuts, bolts and screws
tight to be sure the machine is in
safe working condition.
b) Check the grass collector fre-
quently for wear or deterioration.
c) On machines with multi blade,
take care as rotating one blade
can cause other blades to rotate
d) Be careful during adjustment of
the machine to prevent entrap-
ment of the fingers between mov-
ing blades and fixed parts of the
machine.
e) Always allow the machine to cool
down before storing
f) When servicing the blades be
aware that, even though the
power source is switched off, the
blades can still be moved.
g) Replace worn or damaged parts
for safety. Use only genuine re-
placement parts and accessories.
ADDITIONAL SAFETY INSTRUC-
TIONS ON RISKS DUE TO VIBRA-
TION
a) The declared vibration data rep-
resents the main applications of
the appliance, but different uses
of the appliance or poor mainte-
nance can result in different vibra-
tion data. This may significantly
increase the vibration level over
the total working period.
b) Additional safety measure shall
be taken to protect the user from
effects of vibration. Maintain the
appliance and its accessories,
keep hands warm and organize
work patterns and periods.
FOR USE OF BATTERIES
a) Do not open, dismantle, shred or
short-circuit batteries. Danger of
explosion.
b) Batteries (battery pack or batter-
ies installed) shall not be exposed
to excessive heat such as sun-
shine, fire or the like. Protect from
mechanical shock. Keep dry and
clean. Keep away from children.
c) Dispose of properly. Pay attention
to environmental aspects of bat-
tery disposal. Do not dispose of in
household waste.
d) Remove batteries when not us-
ing the tool for a longer period of
time.
e) In case of battery leakage, remove
the batteries and clean the bat-
tery compartment thoroughly.
Avoid contact with skin and eyes.
f) In case of damage and improper
use of the battery, Vapours may
be emitted. Provide for fresh air
and seek medical help in case of
complaints. The vapours can irri-
tate the respiratory system.
For safety instructions for the bat-
tery charger please refer to the man-
ual of the charger.
For safety instructions for Li-ion bat-
teries please refer to the manual of
the battery.
EN 135