Control Panel; Description Of The Led In The Lower Side Of The Display; Operation; Switching The Device On/Off - Whirlpool ACO D 103 Instructions Pour L'installation, L'emploi Et L'entretien

EN

5. CONTROL PANEL

5.1 DESCRIPTION OF THE LED IN THE LOWER SIDE OF THE DISPLAY

In the lower part of the display there are LEDs that provide important information about the operating mode.
Indicates that a blast chilling cycle is in progress
Indicates that a deep freezing cycle is in progress
Indicates that the current cycle is with temperature control
Indicates that the current cycle is controlled by time
Indicates that a hard blast chilling cycle is in progress
Indicates that a conservation phase is in progress
Indicates that a pre-cooling phase is in progress
Indicates that a defrost is in progress
Indicates that the temperature is displayed in Celsius degrees
Indicates that the temperature is displayed in Fahrenheit degrees
Indicates that the blast chiller is in stand-by

6. OPERATION

6.1 SWITCHING THE DEVICE ON/OFF

Operate as follows: hold the START/STOP key down for 1 s.
When the blast chiller is on, the display shows the temperature inside the cell.

6.2 LOCKING/UNLOCKING THE KEYBOARD

To lock or unlock the keyboard operate as follows:
To lock: hold the down key and the start/stop key down for 1 s: the display will show Loc for 1 s. When
the keyboard is locked, no operation is allowed.
To unlock: hold the down key and the start/stop key down for 1 s: the display will show UnL for 1 s.

6.3 OPERATING CYCLES

The devices can manage the following operating cycles:
• Blast chilling and conservation
• Hard blast chilling and conservation
• Deep freezing and conservation
• Soft deep freezing and conservation.
Blast chilling key
Deep freezing key
Hard blast chilling or Soft deep freezing key
Start/stop (on/off) key
Increase value key
Decrease value key
18