Fine Dine 239193 Mode D'emploi page 6

Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check if the appliance is undamaged. In case
of incomplete delivery or damages, contact the
supplier and do not use the appliance (See == >
Warranty).
• Clean the appliance before use (See == > Clean-
ing and Maintenance).
• Ensure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resistant surface that is safe from water
splashes.
• Ensure that there is sufficient ventilation. Keep a
minimum distance of 15 cm around the appliance.
Suitable cooking equipment
Bottom of cookware
EN
Material
Diameter of the bottom
Type of cookware
Note: Using a pan or pot that's not suitable for induction cooking may damage the appliance.
Operation
• Place a suitable pan or pot at the centre of the
heating surface of the appliance. (See - - > Suita-
ble cooking equipment for the appliance).
Note: Do not place empty cookware as this may
damage the cookware.
• Then, connect the cord of the control box with the
induction plate.
• Connect the power plug to a suitable electrical
socket.
• "- -" will be shown on the digital display (3) and
ON indicator light up. The appliance is in STAND-
BY mode now.
6
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note:
1. Due to manufacturing residues, the appliance
2. There is an optional spare part for item 239193
Suitable
Flat bottom
Cookware with iron, cast iron, magnetic
stainless steel or enamelled iron bottom.
Between 12 cm and 20 cm.
Cookware with a bottom thickness over
1.5 mm.
• Press and hold ON / OFF button (1) for 1 ~ 2 seconds
to start operation.
• Set the power level by pressing increase or de-
crease button (2). (Power level range: 1 ~ 10).
• Now, the appliance starts cooking operation. The
set power level will be shown on the digital display
(3) during operation.
• After finishing, press the ON / OFF button (1) to
switch the appliance to STANDBY mode. And "- -"
will be shown on the digital display (3).
may emit a light odor during the first few uses.
This is normal and does not indicate any defect
or hazard. Make sure the appliance is well ven-
tilated.
only: stainless steel mounting ring (item 239186,
not included) which can be installed together to
fix them in a place.
Not suitable
Curved, uneven, rounded bottom
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Less than 12 cm or more than 20 cm.
Completely closed containers or cans.
will be displayed on (3).