Belkin F1U119 Guide D'utilisation page 17

P73074/F1U119/AM/man.qxd
Assigning Pre-Installed Printers To The Belkin AutoSwitch
Virtual Ports:
• If you are trying to add your printers to Windows
the default, Add Printer Wizard, you will have to use the software that
came with your printer to install the printer. Follow the instructions that
came with your printer, then REBOOT YOUR COMPUTER.
• If your printers are already installed in Windows
to change the port assignment from LPT1 (or any other LPT port) to the
virtual AutoSwitch ports.
Example:
You installed two DeskJets and two LaserJet
are connected to Port A and Port C of the AutoSwitch, and the LaserJet
are connected to Port B and Port D of the AutoSwitch, as shown in the
diagram below:
DeskJet
4/19/00 4:25 PM
Windows 95/98
®
(new switch type)
13
Page 13
(continued)
and it is not listed in
®
® , all you have to do is
™ s in Windows ® . The DeskJets
LaserJet ™
En
™ s