Scan Sensitivity Setting - Fm - Sangean DPR-26BT Mode D'emploi

Scan sensitivity setting – FM
Your radio will normally scan for FM broadcasts which are strong enough to give good reception.
However, you may wish the Auto-scan function to be able to find weaker signals, possibly from
more distant radio transmitters. Your radio includes a local/distant option for the Auto-scan function.
. Press the On/Off button to switch on your radio.
. If needed, press the Band button to select the FM band.
3. Press and hold down the Advanced info button until "FM Scan Zone" appears on the display.
4. Press and release the Tuning control to select FM Scan Zone then rotate the Tuning control to
choose between Local and Distant options, press and release the Tuning control to choose.
The Distant option will allow the radio to find weaker signals when scanning.
5. The radio will then revert to the normal information display. The Local or Distant setting is stored
in the radio and remains in force until changed or until a System Reset.
Note:
The initial setting (out of box or after s System Reset) causes the radio is ignore weak (distant)
signals.

89.30 MHz
1
FM
<Scan Zone
Scan Zone
2
<Distant
Scan Zone
<Local
3
4,5
FM
>
>
>