Power Source; Remote Control - Sharp GX-BT7 Mode D'emploi

Power Source

Wall socket
AC 100 - 240 V ~
50/60 Hz

AC power connection
Notes:
 Unplug the AC power lead from the wall socket if the
unit will not be in use for a prolonged period of time.

Bluetooth stand-by mode
 The fi rst time the unit is plugged in, the unit will enter
the Bluetooth stand-by mode. Pairing indicator will light
up.

Remote control


Battery installation
1
While pushing the locking tab towards the centre of
the remote control, slide out the battery holder.
Back of remote
control
Locking tab
2
Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
Polarity (+)
symbol
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the unit will not be used for a long
period of time.
This will prevent potential damage due to battery leakage.
Caution:
 Do not use rechargeable battery (nickel-cadmium bat-
tery, etc.).
 Danger of explosion if battery is incorrectly replaced.
 Replace only with the same or equivalent type.
 Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fi re
or the like.
 Installing the battery incorrectly may cause the unit to
malfunction.
 To cancel the Bluetooth stand-by mode, press the ECO
MODE button (remote control) during Bluetooth stand-
by mode. The unit will enter the low power consump-
tion mode.
 To return to the Bluetooth stand-by mode, turn the unit
on and off again.
 During Bluetooth stand-by mode, the unit will turn on if
Bluetooth connection is established.
 If iPod, iPhone, iPad or Android-powered device is
plugged in, the unit will begin charging. iPod, iPhone,
iPad or Android-powered device charging is invalid
during Eco mode.
Notes concerning use:
 Replace the battery if the operating distance is reduced
or if the operation becomes erratic. Purchase "CR
2025", coin lithium battery.
 Periodically clean the transmitter on the remote control
with a soft cloth.
 Exposing the sensor on the unit to strong light may in-
terfere with operation. Change the lighting or the direc-
tion of the unit if this occurs.
 Keep the remote control away from moisture, heat,
shock, and vibrations.

Test of the remote control
The remote control can be used within the range shown
below:
Positive (+)
side up
E-4
Remote sensor
0.2 m - 6 m
(8" - 20' )
MUTE ECO MODE
BASS TREBLE
PAIRING
BLUETOOTH AUDIO IN
ECO MODE
ON/
MUTE ECO MODE STAND-BY
BASS TREBLE VOL
PAIRING E SOUND
BLUETOOTH AUDIO IN USB
DIMMER
RRMCGA342AWSA
ON/
STAND-BY
VOL
E SOUND
USB