Greencut MH202-4 Manuel D'utilisation page 54

54
ASSEMBLY AND DISASSEMBLY OF THE ACCESSOR
1. Push the unlocking lever (9) as far as it will go and hold it in this position.
2. Remove the accessory from the unlocked appliance.
3. Allow the unlocking lever (9) to return to its position.
4. Push the attachment along the guide rail on the motor unit. It audibly engages.
5. Allow the unlocking lever (9) to slide back.
6. Check that the appliance attachment is secured by pulling it.
SWITCHING ON AND OFF
1. On: Press the on/off switch (11). the speed. Gentle pressure: low speed Increase pressure: higher speed.
2. Off: Release the on/off switch (11). If you set the direction switch (10) to the centre position the appliance
is secured against switching on
DRILL
DRILL BIT INSERTION
1. Turn the keyless chuck (6) counterclockwise until the opening of the chuck is large enough to accommodate
the tool.
2. Insert the tool as far as possible into the keyless chuck (6).
3. Turn the keyless chuck (6) clockwise to hold the tool.
4. To remove the tool again, turn the keyless chuck (6) and pull out the tool.
GEAR SELECTOR
ATTENTION: Stop the machine before changing gear to prevent damage to the tool.
1. Set the gear selector (8) to the desired position
L=>low speed
H=>high speed
ADJUSTMENT OF THE DIRECTION OF ROTATION
The direction of rotation of the device can be changed with the direction of rotation switch.
1. Wait for the appliance to stop.
2. Set the rotation speed (10) to the desired position:
Clockwise rotation: for drilling and screwing screws.
Counterclockwise rotation: for unscrewing screws.
3. If you turn the direction switch (10) to the middle position, the device is secured against being switched on.
TIGHTENING TORQUE SETTING
Torque settings are labelled as 1 - 19 +
1. Wait for the appliance to stop.
2. Turn the torque adjustment ring (7) to select the desired torque:
Screws: Steps 1 - 19; Drilling: Step.
Start with a lower torque step and increase as needed.