Publicité
Les langues disponibles
Les langues disponibles
2. CONTENT OF THE PACKING
1x transmitter (HDMI Transmitter)
1x receiver (HDMI Receiver)
1x Power adapter
1x User manual
3. CAT5E/CAT6 CABLE REQUIREMENTS
• UTP-, FTP- or STP-cable
• 24AWG or lower
• Solid twisted pair
• 100 ohm at 1MHz
• RJ-45 jack according to EIA/TIA T568B standard
Instead of CAT5e cable, CAT6 cable may also be applied (this offers better quality). Use a
'solid twisted pair CAT-5e or CAT-6 cable' in order to optimise transfer quality.
4. INSTALLATION
4
TV Decoder
HDMI
Blu-ray player
1
MediaCenter PC
In order to check proper functioning of the system, it is advisable to test the set-up first, using
a short CAT-5e/6 cable.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (HD-DVD player, blu-ray disc player, HD set-top box, game
console, etc.) to the MegaView 80 transmitter [1], using an HDMI cable (not provided).
3. Connect the MegaView 80 receiver to the appliance shown [2] (e.g. HDTV or projector),
using an HDMI cable (not provided).
4. Use one CAT5e/6 Ethernet cable to connect the MegaView 80's transmitter to the
receiver [3].
•
The MegaView 80 can either be connected by using a single cable, or through an
existing home network (LAN) in combination with network switches and routers.
•
The RJ45 plug on these cables must be connected according to EIA/TIA T568B
standard, see attachment page 39.
5. Connect the power adapter [4] to the '5VDC' connection on the MegaView 80 receiver
(HDMI Receiver) and plug the adapter into a socket.
4
CAT5e/6
HDMI TRANSMITTER
3
EXTENDER OVER TCP/IP
2
HDMI
H D M I R E C E I V E R
EXTENDER OVER TCP/IP
4
HDTV
© MARMITEK
Publicité
