Maintenance; Conformity Declaration - Radiometrix CTR44 Manuel D'emploi

ENGLISH
Connection of the devices
230Vac mains power supply cable – Terminals 1 and 2 on J5
Warning : The cable's ground pole must be connected to a good ground reference in the gate's nearby area.
Motor 1 – Terminals 1, 2 and 3 on J1
Blinker – Terminals 4 and 5 on J1
Photo-cells power supply – Terminals 1 and 2 on J4
NO start push-button – Terminals 3 and 5 on J4
NC photo-cell contact – Terminals 4 and 5 on J4
NC opening limit switch – Terminals 6 and 8 on J4
NC closing limit switch – Terminals 7 and 8 on J4
Aerial – Terminals 1 and 2 on J3
Important : Before starting the gate check all connections to the electronic card. Check also the electric contacts' switching.
H) MAINTENANCE
Warning : The maintenance of the device must be effected only and exclusively by a specialized technician authorized from the Manufacturer.
Any operation of maintenance or control of the device must be effected in absence of power supply.
Ordinary maintenance: Every time that it is necessary and however every 6 months is recommended to verify the device operation.
Extraordinary maintenance: In case of failure, remove the device and send it for repair to the manufacturer laboratory or to authorized laboratory.
The Manufacturer is not responsible for missing observance of rules above described.
I) CONFORMITY DECLARATION (
To EMC directive EN45014 and ISO guide 22)
Description of the appliance : Electronic board for the control of a 230Vac single-phase asynchronous motor for gate automation.
Model : CTR44
Reference rules applied : EN 50081-1, EN 50082-1, EN 55014
Basic rules applied : EN 61000-3-2, EN 61000-3-3, EN 61000-4-4, EN 61000-4-2, ENV 50140
Test laboratory : Computec
Outcome : Positive
The manufacturer declares that the above listed products comply to the norms on electromagnetic compatibility provided for by directives 89/336/EEC,
92/31/EEC, 93/68/EEC.
Casalmoro , 20-01-2004
16