EUROM HVF14-2 Manuel D'utilisation page 11

Assembly (only HVF18S-2)
1. Fan body including frame
2. Telescopic stand
3. Holder
4. Decorative cap
5. Foot
6. Large screw including plate
8. Clamping screw
1. Put the holder (3) together with the
telescopic stand (2) in the foot (5);
there are recesses to attach the
screws to the foot.
2. From the bottom side, insert the
large screw together with the plate
(6) through the foot into the holder
and turn the holder tightly onto the
foot.
3. Put the holder including the foot in
an upright position and slide the
decorative cap (4) over the
fastening.
4. Slide the mounting tube of the frame (1) into the telescopic stand (2) (see the
illustration.), screw holes should align with screw holes. Insert both screws
through the telescopic stand into the mounting tube. Tighten them using both
nuts.
5. Set the required height by (a) loosening the clamping screw (8), (b) setting the
telescopic stand to the required height and (c) tightening the clamping screw.
6. Check that everything is secured properly. Never use the fan before it has been
fully assembled!
Operation (for all models)
Before using the device, make sure all of the safety
guidelines have been taken into account.
 Operation button (at back) to 0.
 Insert the plug into the socket.
 Choose the setting desired:
1 = low (pleasant breeze)
2 = average (powerful breeze)
3 = high (very powerful wind)
Back to 0 = switch off
In order to switch off, always turn the button to 0
then take the plug out of the socket!
11