Inateck BCST-70 Mode D'emploi page 6

Status indication
EN
Buzzer Indication
Beeping
One short high note（100ms）
One short high note（20ms）
One long high note（400ms）
Two or more long high tones（800ms）
Three chord sounds
Two short notes（tone from low to high）
Two short beeps (tone from high to low)
Chords sound（high to low）
Two short tones
LED Indication
Indicator color
Green LED flashes once (LED2)
Blue LED flashes once (LED2)
Blue LED stays on (LED2)
Yellow LED blinks（light/shade ratio0.5s :
0.5s） (LED1)
Red LED stays on (LED1)
Flashing green light
Frequently Used Barcodes
Enter Setup
Exit without Save
3
Meaning
Read barcode successfully
Data upload from scanner to Computer
Wrong Setup （on setup status, blue LED stays on）
Invalid scanning due to full buffer (Scanned barcode not saved.)
Pairing Failure (Occurs only during the pairing process)
USB being configured（It happens when USB cable is inserted）
Enter setup mode（Blue LED on）
Exit setup mode（Blue LED off）
Correct Setup
The connection between Inateck BCST-70 and computer is disrupted.
Prompt successful Bluetooth connection
Prompt disruption of Bluetooth connection
Meaning
Barcode successfully read and uploaded to computer
Barcode successfully read and saved in buffer, but not uploaded to computer
Inateck BCST-70 scanner on setup status
Low battery
Inateck BCST-70 scanner in charge (Red LED off when battery is full)
Ever paired but not successfully connected this time
Exit with Save
Restore Factory Setting