LENCO LFM-220BK Mode D'emploi page 25

Turning on the unit
NOTICE! Fire hazard
Do not operate the
Connect the device to the mains and switch the device to "Light &FOG" with the Power switch.
Allow the unit heat up 5 – 6 minutes
As soon as the required operating temperature is reached, the green LED on the wired control
will light up, meaning the device is operational.
Operating:
When operating the fog machine, always ensures that there is sufficient fog liquid in the liquid
tank to avoid no-load running.
Operation with an empty liquid tank can lead to overheating and permanent damage
of the pump
WARNING: When the fog machine is in use don't touch the top of the casing
and the Fog nozzle on the front since they will get hot.
Never aim the fog nozzle directly on people within a range of 50cm when in
use. The ejected fog is very hot!
Turning the unit off
Allow the LFM-220BK to keep unused for several minutes before switching the Power Switch
to OFF.
Turning off the power switch during fog production can cause damage to the heat exchanger.
Allow the LFM-220BK to cool completely before packing/storing.
The nozzle of the LFM-220BK may remain hot for up to 10 minutes after power is
shut off.
Switch the device "OFF" with the Power switch. Disconnect the device from the mains.
Transport the device only when it is completely cooled down.
To avoid leaking fog Liquid during transport, you should transport the device only with empty
liquid tank.
WARNING
If the machine will be unused for an extended period of time, follow the Storage and Shipment
instructions listed under Maintenance to prepare the machine for long-term storage.
Wired Control
Press and hold the "RED" button on the wired control to spray the fog.
When the green led is off, you have to wait until the unit's temperature is high enough before
You can spray fog
LFM-220BK
unattended.
25
OPERATING