LENCO LFM-220BK Mode D'emploi page 24

INSTALLATION
Unpack and carefully check that there is no transportation damage before using the unit. Keep
the equipment packaging. To fully protect the device against vibration, dust and moisture
during transportation or storage use the original packaging or your own packaging material
suitable for transport or storage, respectively.
The device should be located on a secure, solid surface such as the floor. The machine can
operate in any orientation from 45 degrees upwards to 45 degrees downwards. Take
precautions to avoid Liquid spills if the machine is oriented at an angle.
Do not connect the unit to the mains before checking the mains voltage and before all other
connections have been made.
2. Precautions/ safety warnings
- The LFM-220 was developed for private use only, link parties, disco party etc.
- The LFM-220 is only approved for a mains connection up to 230 VAC 50/60 Hz
- Regular breaks during operation will increase the lifetime of the LFM-220.
- Take care that no cables are lying around. You would endanger your own safety and also
the safety of a third party.
- Keep the LFM-220 dry and keep it away from water or high humidity. It could reduce the
isolation of the device and cause short circuit and/or electric shocks.
- When using the LFM-220 fog machine you have to ensure that there is still a good
visibility of at least 10m.
- Don't operate the device during thunderstorms. Surge voltages can damage the device.
Unplug the LFM-220 from the power supply during thunderstorms.
- Keep Surrounding objects at a safe distance of >1m
- Keep the device away from children and never operate it unattended.
- Never aim the nozzle directly on people; the ejected fog is very hot!
- Never use flammable substances, oil, gas, perfumes, etc. in your fog fluid.
- Never aim the nozzle on open fire or flammable objects.
- Make sure to fill the LFM-220 with fog fluid in time. If the machine is operated without fluid
it can cause damage to the pump or the heating block.
- When removing the Fog fluid, first unplug the device from the power supply.
- Never drink the fog fluid. If this does happen, please contact a doctor. If the fluid came in
contact with the eyes, immediately rinse with a lot of water.
Fog Operating
Filling the unit
NOTICE!
Possible damages caused by unsuitable fog liquid.
Warning: don't use Oil based Haze fluids. These will damage the LFM-220
First, make sure the unit is disconnected from the mains
Open the screw-cap of the liquid tank and fill in the fog Liquid. Make sure that no fog Liquid is
spilled or gets into the device. The easiest way is using a funnel. The tank capacity is 1.0 litre.
Make sure the little filter of the tank hose is immersed into the smoke fluid. Firmly screw the
cap back onto the tank
NOTICE! The tank hose opening in the cap is NOT fluid tight. When transporting the
LFM-220 firstly remove the unused smoke fluid to prevent smoke fluid coming out and
damaging the LFM-220
24
OPERATING