Geberit ECO 301 Manuel D'utilisation page 20

EN
Original operating instructions
Safety
Target group
This tool may only be used by skilled persons in accordance with EN IEC 82079-1:2012.
Intended use
The Geberit pressing tool ECO 301 is only allowed to be used for pressing pipes and
pressfittings of the Geberit Mapress pressing systems.
Only pressing attachments (pressing jaws, adapter jaws, pressing collars) with the
compatibility mark
regarding compatibility and the maximum pressing areas can be found in the country-specific
product range catalogues.
The pressing tool is not suitable for continuous operation. After 30 minutes of continuous
operation, a break of at least 15 minutes must be taken to allow the pressing tool to cool.
Any other use or a use extending beyond the intended application is deemed to be improper.
Geberit will not accept any liability for any resulting damage.
Basic safety notes
WARNING
Risk of injury caused by flying fragments if used incorrectly or if worn or damaged
pressing attachments are used
• Only use the pressing attachments if they are in perfect working order
• Examine the pressing attachments regularly before and after each use for defects,
particularly for cracks in the material in the pressing contour and the retaining bracket of
the jaws, and also for other damage. If there are cracks in the material, take the entire
pressing attachment out of service immediately and do not use it again
• Do not use a pressing attachment again after it has been used incorrectly or in a way that
does not comply with its intended use. Instead, hand it over to an authorized repair shop
for testing
• Adhere strictly to maintenance regulations and maintenance intervals for the pressing
attachments and the Geberit pressing tool
• Wear suitable protective equipment (protective goggles etc.)
• Follow the country-specific safety regulations
• Read all safety notes and instructions. Failure to observe the safety notes and instructions
can lead to electric shock, fire and/or serious injuries. Store all safety notes and
instructions for the future
20
may be used with the Geberit pressing tool ECO 301. Overviews
B266-004 © 05-2015
964.869.00.0 (03)