Factory Setting; Cleaning - Graef CM 900 Notice D'utilisation

The „P" button will stay fully illuminated,
● ●
while the
soften in brightness.
Notice: The programming mode can be aborted
at any stage by pressing the „P" button again.
Select either the
● ●
the grind time for that selected button. The
selected button will begin to flash, and the
grinding will become activated.
Coffee grounds will begin to fall into the
● ●
group handle.
To stop the grinding process and set your
● ●
programmed
re-select the
previously selected (this is indicated by
the flashing button). The motor will be de-
activated, and the time of the selected
function will be stored.
Notice: The grind setting should no longer be
altered, in order not to change the quantity of
coffee grounds. After an alteration of grind set-
ting, the programming has to be repeated.
Allowable program time for
● ●
16
button and buttons will
or button to program
or grind amount,
or button that was
buttons 2 is sec – 40 sec.

Factory setting

Press „P" button for 5 seconds. All 3 buttons
will flash.

Cleaning

Old coffee grounds remaining in the appliance
can lead to oxidation. That spoils the beverage;
it can cause an unpleasant, rancid taste.
The appliance should always be in optimum
condition to be able to provide optimum results
at any time.
Ensure the appliance is switched off and
unplugged from the power socket.
Clean the exterior of the appliance with a
● ●
soft, moist cloth. If heavily soiled, a mild
or
detergent can be used.
Take off the coffee bean container. Press it
● ●
down and turn counter-clockwise.
Take out the unused beans and put them in an
● ●
airtight container so they stay fresh.
and