Dometic PERFECTVIEW Switch200VTO Instructions De Montage Et De Service page 11

SWITCH200VTO
5.1 Connections
The control box has the following connections:
No. in
1
2
3
4
5
6
7
8
9
10
11
EN
Connection description
Red cable: connection to 12 V to 34 V positive (e.g. connected positive
terminal, terminal 15)
Black cable: connection to earth (terminal 31)
Green control cable (+ signal) for connecting the positive cable of the
reversing light
When you shift into reverse gear, the control box is activated via this cable.
Yellow control cable (+ signal, video trigger out) with AMP Quadlok plug
contact for controlling the camera activation signal of lorry multimedia
systems
When the camera input is active, this signal has a level of +7.5 V. When the
camera input is switched off, it is switched to earth.
Connection of the rocker switch supplied for switching between the two
camera inputs manually.
Dip switch for mirroring the camera image manually and for switching
between long-distance and close-up manually (provided the camera
supports this function)
Camera input 1
Camera input 2 with trailer detection
Potentiometer for adjusting the delay between the video signal and video
trigger signal (0.8 s to approx. 3 s)
Audio output for connecting to audio inputs using a cinch connector
Video output (cinch socket) for connecting...
• diverse multimedia navigation systems and lorry monitors in combination
with the corresponding adapter
• another monitor with a video input (cinch socket) or a video recorder.
Technical description
11