HEIDENHAIN ND 2100 G GAGE-CHEK Guide De Démarrage Rapide page 3

ND 2100 G GAGE-CHEK
Setup
For detailed description, see www.heidenhain.de
Before Power up
Electrical connection
Line voltage: 100 V~ to 240 V~
(–15 % to +10 %)
Line frequency: 43 Hz to 63 Hz
Line fuse: T1600 mA, 250 V
5 x 20 mm
Power connector wiring
L: Line voltage (brown)
N: Neutral (blue)
Earth ground (yellow/green)
Danger of electrical shock!
• Do not open the enclosure.
• Never use 3-wire to 2-wire adapters
or allow the ground connection to
the ND 2100 G to be interrupted or
disconnected.
Caution
Changes to the power cable may be
made only by an electrical technician.
Caution
Do not connect encoders or other
equipment to the ND 2100 G when the
power is on.
Safety Considerations
General accepted safety precautions
must be followed when operating the
ND 2100 G. Failure to observe these
precautions could result in damage to
the equipment, or injury to personnel.
It is understood that safety rules within
individual companies vary. If a confl ict
exists between the material contained
in this guide and the rules of a company
using this system, the more stringent
rules should take precedence.
Controls and Displays
A LCD screen
B Soft keys change to support
functions.
C Dimension keys display
dimension values or graphs.
D Command keys control
measurement activities.
E Arrow cursor keys for menu
navigation.
F Numeric keypad for entering
numeric data.
G Fast track keys are
programmable for frequently
used functions.
H
Send key transmits data to a PC,
USB printer or USB drive.
I
LCD on/off key turns the LCD on
or off or clears stored data.
Connections rear side
1 Power switch
2 Power connection with fuse
3
Ground (protective ground)
4 Encoder inputs are inputs for
dimension formulas. The encoder
interface is specifi ed at the time
of purchase.
5 Relay outputs are two sets of
signalling relay contacts that
open and close under the control
of ND 2100 G formulas.
Caution
• Max contact voltage:
100V
• Max contact switching current:
250 mA
• Max contact carry current:
500 mA
• Contact rating:
3 Watts
• Static contact resistance:
0.20 Ohms
6 Parallel I/O port reads and
writes standard TTL levels
under the control of ND 2100 G
formulas.
7 RS-232-C interface for PC
connection. RS-232 cable must
not include crossovers.
Connections side view
8 Audio out, for 3,5 mm
headphone /speaker jack,
monaural, 8 Ohm
9 USB Type A interface for printer
or data storage.
10 Remote accessory interface
RJ-45 for optional foot switch or
keypad accessory. Two optional
remote accessories can be used
simultaneously using an RJ-45
splitter.
Mounting
The ND 2100 G is secured to the
swivel slots of the mounting stand or
arm mount by a shoulder screw, a cap
screw mount is shown with associated
washers.
Very important
Please note
For your information
DR. JOHANNES HEIDENHAIN GmbH
Dr.-Johannes-Heidenhain-Straße 5
83301 Traunreut, Germany
{ +49 8669 31-0
| +49 8669 5061
E-mail: info@heidenhain.de
www.heidenhain.de
English
1