Operating Determinations; Installation; Rigging - EuroLite LED DWL-2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The electric connection must only be carried out by a qualified electrician!
This device falls under protection-class I. Therefore it is essential that the yellow/green conductor gets
connected to earth. The electric connection must be carried out by a qualified employee.
Make sure that the available voltage is not higher than stated on the rear panel.
Always disconnect from the mains, when the device is not in use or before cleaning it.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a fixed general purpose luminaire. This product is only allowed to be operated with an
alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
- - -m
The symbol
between light-output and the illuminated surface must be more than 0.1 meters.
Make sure that the area below the installation place is blocked when rigging, derigging or servicing the
fixture.
Operate the device only after having become familiarized with its functions. Do not permit operation by
persons not qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.

INSTALLATION

Rigging

When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The installation of the luminaire has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
DANGER TO LIFE!
determines the minimum distance from lighted objects. The minimum distance
DANGER OF FIRE!
9/19
00029828.DOC, Version 1.1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Led dwl-4Led dwl-6

Table des Matières