Dometic PerfectView CAM604 Instructions De Montage Et De Service page 19

PerfectView CAM604
If you want to screw on the camera with self-tapping screws (fig. f,
page 6):
A
NOTICE!
Self-tapping screws may only be fastened to steel metal with a minimum
thickness of 1.5 mm.
➤ Drill the holes, with a Ø of 6 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using 6 x 20 mm self-tapping screws.
If you would like to attach the camera with threaded screws fitted through
the construction (fig. g, page 6):
A
NOTICE!
Ensure that nuts cannot be pulled through the body shell when they are
tightened.
Use larger washers or metal plates if necessary.
➤ Drill the holes, with a Ø of 6.5 mm, at each of the markings.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the camera bracket using M6 x 20 self-tapping screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
EN
Fitting the camera
19