Publicité
Les langues disponibles
Les langues disponibles
USING THE APPLIANCE
Note: This device is designed for one person only. We do not recommend sharing it with other people.
Inserting the batteries
Open the battery compartment cover and insert 3 (AAA) batteries. Observe correct polarity of the batteries (+)
and (-). Replace the battery compartment cover after inserting the batteries.
Function of individual attachments
Epilator
The epilator rotating discs made of hypoallergenic stainless material remove e ciently and gently even the
nest hair.
Shaver
The double foil shaver allows for smooth and convenient shave.
Foot sander
The sanding roller with a unique surface made of silicon carbide removes hard skin gently and delicately. The
GB
sander with the carborundum roller is more e cient and safer than using metal scraper.
Removing the attachment: Hold the device with one hand, press the attachment release button and remove
Inserting the attachment: Hold the device with one hand and insert the attachment correctly with the other
Using the epilator and the shaver
•
Before rst use of the epilator we recommend to try it on a less hairy area.
Alert: Keep the device away from hair, eyelashes and eyebrows. Never use the epilator on your face.
•
•
Clean the skin before hair removal and remove all dirt and dry it. (Hot water makes sure that the pores are
open and the hair removal more pleasant). Make sure that the areas which you want to epilate are dry,
clean and free of cosmetic creams or oils.
1.
Make sure before use that the batteries as well as the required attachment are correctly inserted.
2.
Remove the protective cover, press the switch lock and slide the switch to turn the device on. We
recommend that you use only lower speed when using rst time.
3.
Gently place the device on the required area and remove the hair moving slowly. Make sure that the
treated skin is always taut and the device at right angle to the skin.
4.
Remove the attachment after use and clean it using the cleaning brush.
Using the foot sander
1.
Make sure before use that the batteries as well as the attachment with sanding roller are correctly inserted.
Do not use the device without the sanding roller in the attachment.
2.
Remove the protective cover, press the switch lock and slide the switch to turn the device on. Select the
required speed by sliding in the appropriate position.
3.
Move gently over the hard skin from side to side or backward and forward.
4.
Check after 2-3 seconds (without switching o the device) if you achieved the required result. If not, move
over the area next 2-3 seconds and check the result again. Repeat, until you achieve the required softness
of skin.
5.
Rinse the skin or wipe it with damp towel to remove residues of the sanded skin.
6.
Remove the attachment after use and clean it using the cleaning brush.
7.
Treat the skin with moisturising cream.
Attention: Do not apply to one spot for longer than 3-4 seconds at a time. In case of irritation or redness end
the procedure. Do not press too hard on the skin.
2 0 2 0 2 0
the attachment with the other hand.
hand. When inserted correctly, you hear „snap" of the attachment.
Publicité
