Operation - DS Produkte Z 03139 Mode D'emploi

EN

Operation

ATTENTION!
• Do not use the device on wet hair. Your hair must at least
be towel-dried!
• Check the device for damages prior to each use. The device
may not be used if it, the mains cord or plug exhibit visible
damages. Do not use the device if it malfunctions, has fallen
down or in water.
• The brush becomes hot during use. Be careful when han-
dling the brush and only hold the device by the handle.
Keep the brush away from your face, especially your eyes.
Also keep a safe distance of at least 3 – 5 cm between your
head and the brush.
Start-up
1. Connect the device to a properly installed socket that corre-
sponds to the device's technical data.
2. Select a temperature setting with the On/Off switch:
– I (low temperature setting; approx. 150
light is illuminated in green.
– II (high temperature setting; approx. 200 °C). The control
light is illuminated in red.
3. Set the On/Off switch to the 0 position if you would like to
turn the device off. The control light will turn off. Always pull
the mains plug out of the socket when you are not using the
device.
24
°C). The control