Publicité
Les langues disponibles
Les langues disponibles
GB
Operating instructions
ITF-100
The LED will light up red 2x.
If no scene switching is required, the settings are now complete and you
can proceed to mount the switch.
How to save scene switching (Fig. 3)
Only for wireless receivers which are suitable for scene switching
3
(SYMBOL)!
3 different scenes can be saved.
Scene settings are automatically adopted if two or more scene
switching-compatible transmitters are used and encoded with the same
wireless receivers.
To set a scene with several wireless receivers, it is recommended you use
a handheld transmitter such as the ITLS-16, ITT-1500, etc.
Use it to set your wireless receivers to the desired state, e.g. setting the
desired brightness or switching devices on or off.
If no other handheld transmitter is available, the wireless scene
transmitter in slider position 1 can be used to program the settings of
one wireless receiver after another, the last selected brightness setting
remains the same for dimmers when they are switched off.
Scene 1: Move the slider to position 3 and press once for scene 1.
The LED will light up green 3x as confirmation and orange 1x for scene 1.
Scene 1 is saved!
Scene 2: Again select the settings and move the slider to position 3 and
finally press 2x.
The LED will light up orange 2x.
Scene 3 is taught in by pressing 3x, the LED will light up green 3x and
orange 3x.
If all 3 scenes have been saved, move the slider to position 2.
Press accordingly to activate each scene.
1x for scene 1 the LED will light up orange 1x as confirmation
2x for scene 2 the LED will light up orange 2x as confirmation
3x for scene 3 the LED will light up orange 3x as confirmation
›
To turn of all scenes, simply press and hold for longer (approx. 2 secs),
the LED will light up red 2x.
Publicité
