AEG HR 5627 Mode D'emploi page 46

English
46
Cleaning and Maintenance
WARNING:
Before cleaning the handset with water, disconnect it from the connection cable.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
This device can be cleaned under running water.
1. Switch of the shaver.
2. Press the shaving head buttons.
3. Rinse the shaving head and the two cutting units under running hot water. Clean the
shaving head in soapy water once in a while.
4. Rinse thoroughly with clear water afterwards.
5. Let the cleaned parts dry.
Alternatively, clean the shaver with the brush provided.
CAUTION:
The shaving foil must not be cleaned with the brush.
• Use the brush to clean the cutter block and the inside of the shaving head.
Maintenance and replacement
• Clean the cutter block thoroughly once a month. If necessary, use special cleaning aids
available in specialist shops.
• Lubricate the shaving foils and long hair cutting attachment with a light machine oil (a
few drops suffice).
Replacement of shaving parts
In order to guarantee a 100% shaving performance, replace the shaving foils and cutting
block every 18 months at the latest or if the shaving parts show signs of wear. It is recom-
mended to replace both parts at the same time.
Noise emission
The workplace-related emission value is less than 70 dB(A).