Heaven Fresh HF 710 Manuel D'utilisation page 7

OPERATING INSTRUCTIONS
Plug in the power, and then press the on/off switch to turn ON the humdidifier.
Buttons instruction
On/off : Press it once, the machine will start working with LCD display on.
Press this button again and the machine will stop working and will go to the standby mode.
Timer: Timer can be set from 1-12 hours
AUTO: Pressing this button will move the machine into automatic control mode.
The device will choose suitable humidifying level as per environmental humidity
and maintains the humidity between 55% - 65%.
Mist Volume: Cool mist steam volume can be changed from level 1 to 3 by pressing this key.
Set Humidity: Humidity can be increased from 40% to 80% at every 5%.
(Machine automatically checks the humidity when it is turned ON)
Constant humidity: The machine controls the humidity automatically when set at a specific
percentage. For example, if you set the humidity at 50%, the machine will check environment
to see if it has reached 50%. The machine will keep working if it is less than 50% and will stop
working when it reaches 50% or above. Machine will start working again when the humidity
goes down by 4% (less than 46%) and has remained idle 3 minutes.
NOTE: When the device is turned on, it will keep working for 1 minutes even if the
environment humidity reaches the set humidity.
Warm Mist: Press this button to get warm mist from the humidifier. This button has 4 states
Max, Med, Low and Off. When the warm mist function is off, the machine only produces
cool mist.
NOTE: Sleeping Mode: Press and hold *
the machine will enter into Sleeping Mode and the display will turn OFF. You can turn the
display ON by pressing any one of the single buttons.
* and * *at the same time for 2 seconds,
HF 710