Festool CTL SYS Notice D'utilisation D'origine page 14

CTL SYS
GB
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1

Regularly replace the filter bag and clean the
container and seals.
Observe the following instructions:
– The manufacturer or an instructed person must
perform a dust test at least once a year to deter-
mine whether the filter is damaged, the machine
is sealed properly and the monitoring features
are functioning correctly.
– Anything that cannot be cleaned must be dis-
carded in impermeable bags. Observe applicable
disposal regulations!
9.1 Changing the filter bag

Open dust extractor with T-Loc [6]. Attention:
Risk of tilting!

Changing the filter bag:

Remove filter bag [7].

Insert a filter bag [8].

Close dust extractor with T-Loc.
9.2 Changing the filter element [9]
NOTE
Motor damage

Never operate the extractor without a filter ele-
ment fitted as the motor may become damaged.

Open dust extractor with T-Loc [6]. Attention:
Risk of tilting!

Unlock and fold down lever.

Remove container upwards.

Remove used filter element and replace with a
new one.

Dispose of the used filter element in accordance
with statutory regulations.

Clean container and seals.

Insert container. Fold up and lock lever.

Close dust extractor with T-Loc.
 The order numbers for accessories, filters and
consumables can be found in the Festool cata-
logue or on the internet at www.festool.com.
14
10 Troubleshooting
Flow noise during dust extraction
Automatic bypass: A valve opens that supplies the
turbine with cooling air:
cause Blocked filter element, filter bag full or
blocked suction hose
Solution Empty container, replace or clean filter
element, replace filter bag, check suc-
tion hose for blockage and remove, if
necessary
11 Transport
Observe the following instructions:
– Before transportation, always close the T-Loc at
the dust extractor or connect to the storage box.
– For transportation in vehicles, secure the device
against slipping and tilting in accordance with the
valid guidelines.
12 Environment
Do not dispose of the device in household
waste! Recycle devices, accessories and
packaging. Observe applicable national regu-
lations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and imple-
mentation in national law, used electric power tools
must be collected separately and handed in for envi-
ronmentally friendly recycling.
Information on REACh: www.festool.com/reach
13 EU Declaration of Conformity
Dust extractor
CTL SYS 500162, 500164, 500165, 500922
Year of CE mark: 2014
We declare under sole responsibility that this product
complies with all the relevant requirements in the fol-
lowing directives, standards and normative documents:
2006/42/EC, 2004/108/EC (until 19.04.2016), 2014/30/
EU (from 20.04.2016), 2011/65/EU, EN 60335-1:2012,
60335-2-69: 2009, EN 55014-1:2006+ A2:2011, EN
55014-2:1997+ Corrigendum
A2:2008, EN 61000-3-2:2006+ A1: 2009+ A2:2009, EN
61000-3-3:2013.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical Documentation
Serial no.
1997+ A1:2001+
2015-03-18