König Electronic HC-BM10 Mode D'emploi page 7

MATCHING (PAIRING)
WARNING!!
This product has already been matched (paired) in production and users DO NOT NEED to perform any
matching procedure under normal conditions. Follow these steps to re-match the Parent unit with the Baby unit
only when it is ABSOLUTELY NECESSARY:
1. Turn both the Parent and Baby units ON.
2. Press the CODE Button (11) located at the back of the Baby unit, the LED turns orange and flashes, and
then press the CODE Button located on the lower right-hand corner inside the battery compartment of the
Parent unit for 3 seconds. The LED of the Parent unit also turns orange and flashes. The two units now
pair automatically. When pairing is successful, the LEDs will turn back to green.
TROUBLESHOOTING
Problem
No reception or transmission on
the Parent unit.
No reception or transmission on
the Baby unit.
The Night Light does not turn on. •
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused
due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for these
products.
Possible Cause – things to do/check
• The unit has not been switched on.
• The AC/DC adaptor has not been connected.
• The rechargeable battery pack is not installed properly.
• Battery power is low. Recharge the battery with the AC/DC adaptor
or put it back to the charging base.
• The Baby unit may not be transmitting.
• The unit has not been switched on.
• The AC/DC adaptor has not been connected.
• The volume level is set to lowest. Adjust volume switch.
The Night Light switch is not set properly.
• Switch the Night Light control to either ON or AUTO.
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician when service is required. Disconnect the product from
mains and other equipment if a problem should occur. Do not expose the
7